Weekly blog post 2

This week I meet with my group and start printing out our own models 

There are still some problems of the model. For example, the size of the model should be bigger than the one in rhino. And the base line should be thinner, my group mate helps me to make the base by using “offset” function. Thanks to my group. 

Moreover. My model was intended to build with two layers, so the outside layer is different than the inside. But after printed out, it’s a little bit hard to see the texture because it is too small.  

Here is the design. It looks so good in rhino. Because I can see both of the layers  

But here is the reality........

I think I need to try change the size of the model. Or make another one, with only one layer.